Greddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 Uživatelský manuál

GReddy Supercharger Kit 2000-2002 Toyota Celica GT-S (ZZT231) MP62 Supercharger kit ―１―

(3) Cut off the OE injector harness connectors and replace with Kit injector harness connectors. ※ ※ ※ ※ ※ Mark or label harness wires to

３－11 Kit Intake Tube Installation (1) Remove the studs on the OE intake air surge tank and screw them into the Kit intake tube. 〈Part №３

Bracket A Bracket B For Vehicles With Auto Cruise Control ① Place the rubber grommets removed in step 2-7 between the cruise control unit and

Harness GrommetGround A B ３－13 Kit e-manage Ultimate installation (1) Remove the ECM box cover and disconnect and remove connector A, B,

ｅ－ｍａｎａｇｅ Ｕｌｔｉｍａｔｅ Connector Harness Pin Location Ｃ Ｂ Ａ ※ Viewing from wire harness side. Ｕｌｔｉｍａｔｅ Pin № Signal （Color） OE ＥＣＭ Pin № Sign

These wire are outlined in the e-manage diagram. These wires will not be used in this kit. Use electrical tape to cover the ends

(6) Route the e-manage ultimate wire harness safely though the engine bay and use cable ties to secure the harness and prevent it from moving. Pla

３－16 Starting the Engine (1) Install the radiator reserve tank to its original location and fill with coolant. Bleed the air from the cooling syst

Front Fender Apron & Dash Panel

Cylinder Head

SUPERCHARGER KIT Toyota Celica ＺＺＴ２３１（２ＺＺ－ＧＥ） Installation Manual Please read the manual carefully before installing and using this product. This

Suspension Cross Member and Under Cover

Switch and Relay

Air Cleaner

Fuel Injection System

Ventilation Hose

Cylinder Block

Manifold

１．Parts List １．Supercharger ＭＰ６２ （W/ Pulley） １ ２．Intake Manifold １ ３．Intake Tube １ ４．Tensioner Pulley １ ５．Supercharger Belt （６ＰＫ－２４７５） １

Part List Diagrams/Pictures １ ２ ３ ４ ５ ６ ７ ８ ９ １０ １１ １２ １３ １４ １５ １６ １７，１８ １９ ２０ ２１ ２２ ２３ ２４～３２ ―

２．OEM Parts Removal Please refer to factory repair manual for OE component removal guidance. ２－１ Safely remove pressure from fuel lines. (１) Re

３．Kit Install ３－１ OE ventilation Tube No. 1 Modification Remove the bracket from the ventilation tube in 2-13. Install back to same locati

３－３ Kit Supercharger assembly (1) Screw in the provided stud bolts onto the supercharger outlet flange and apply silicone sealant to the fl

Kit dipstick guide OE dipstick guide ３－５ Kit Oil Dip Stick Installation (1) Remove the O-ring from the OE dipstick guide and place it on the Kit dip

３－８ Kit V Ribbed Belt Installation. Adjust the tensioner pulley toward the front of the vehicle to adjust belt tension. 〈Part №５〉 ＶＰ ：