Greddy FATT Full Auto Turbo Timer Uživatelský manuál

Instruction Manual

0-200mModeAttackModeSpeedModeSetupMode0-400mModeSpeedometerModeSoundMode200-400mModeSpeed peekModeLine SwitchMode0-100km/hModeSpeed WarningSet upModeR

Operation CheckParking Brake Safety Feature Operation Check10P+SP+SThis shows P-1 selected.Count down begins.During count down, release the parking br

Operation CheckVehicle Speed Signal Safety Feature Operation Check11(2)(1)Go over check procedure 4.3 "Parking Brake Feature Check"before co

Countdown ModeAuto Countdown Mode12Auto Timer Mode automatically calculates a suggested count down timefor your vehicle, according to your car’s RPM.

Countdown ModePreset Mode13There are two Preset Countdown mode you can select from. Preset mode can be set from 0 sec. to 9 min 59 sec. by increments

Battery ModeBattery Voltage Display Mode14This feature displays the "real-time" battery voltage.There is a voltage warning feature that can

Battery ModeVoltage Warning Display Mode15When the Warning is set, the warning buzzer and the back light will flash when the voltage exceeds the set v

Stopwatch ModeLap Mode16This feature can record up to 30 lap times from 0 ~ 9’ 59" 99. Also while recording the time, the best lap will be indi

Stopwatch ModeLap Read Mode17This feature allows the user to look over the recorded lap times.Up to 30 lap time can be recalled one by one. The best l

Stopwatch ModeSplit Mode18This feature can record up to 10 split times from 0 ~ 9’ 59" 99. Lap timecan also be recorded at the same time. (1) W

Instruction ManualTurbo Timer 1pc.Power Harness1pc.Tie Strap3 pcs.Double-sided Tape1 setParts ListImportantPlease check the list below to make

Stopwatch ModeSplit Read Mode19This feature allows the user to look over the recorded split times.Up to 10 split time can be recalled one by one in or

Attack Mode0-200m, 0-400m, 200-400m, 0-100km/h, 0-200km/h, 50-1000km/h Mode20This feature allows the user to record 0-200m, 0-400m, 200-400m, 0-100km/

Attack Mode21Countdown start by pressing T button"Beep""Beep"The timing will start with a "Beep" as soon as the vehicle

Speed ModeSpeedometer Mode22This feature allow the user to monitor the "real time" vehicle speed. With use of the Speed Warning feature, buz

Speed ModeSpeed Warning Mode23This feature allow the user to set the warning speed to warn the driver when the speed exceeds the set warning speed wit

Speed ModeSpeedometer Setup Mode24This feature allow the user to set the Turbo Timer speedometer to match the vehicle’s speedometer. (1)While in Speed

Setup ModeSound Mode25This feature allow the user to turn the sound ON or OFF. (1) While in Setup Mode, press the P+S button to go to Setup

Setup ModeLine Switch Mode26This feature is used when the count down does not properly operate. If the engine shuts down when the IG key is turned of

Setup ModeRPM Set Mode27This feature is used when the Auto Mode does not operate properly or toset the Turbo Timer RPM to match the vehicle’s tachome

Installation (using Optional Turbo Timer Harness)Important!A bad ground connection can lead to a mechanical failure, therefore please attach the groun

Installation (without Optional Turbo Timer Harness)(1) Follow the key switch to it’s electrical connector, then unplug the harness. Find the approp

Wiring DiagramThe wires coming out form the keyswitch usually consist of:12 v - 12 volt constant powerON - Ignition powerACC- Accessory powerST -

Harness ConnectionsBrown / Parking do not use Graynot usedin the USTurboTimer 2-pin connectorPurple / SpeedParking Brake Feature:(1) Remove the cover

Turbo Timer Functions6OPTION SwitchUsed to connect the Remote Switching System (sold separately)Back Line Switch DisplayTIME Button (Referred as "

Display Description71234657118109Attack Mode indicator. Flashes when Attack timer is activated. Stopwatch Mode indicator. Flashes when the stopwatch i

Display Description8StopwatchModeVoltageDisplayModeLapModeBatteryWarningLo ModeBatteryWarningHi ModeLap ReadModeSplitModeSplit ReadModeAutoLo ModeAuto