To be completed by GReddy Serial Number Date Received Date Sent TD04-19T Golf IV Turbo Kit ECU Chip Upgrade Form Thank you

(4) Install four M8x38mm stud bolts to the outlet of the exhaust housing. 〈Part № 52〉 (5) Connect the provided vacuum hose to the a

※ Route the oil pressure hose behind the heater hose and use cable ties to secure the hose. (3) Use the stock oil return pipe to

(3) Place the provided downpipe to fit inside the cut catalytic converter. Connect the muffler piping to the other end of the catalytic converter

(8) Install the factory drive shaft heat shield. ※ Use factory bolts. ※ Please check to make sure there is clearance around the heat shield af

(5) Install Airinx bracket to air filter and body using provided black M6 bolts that came with Airinx filter. 〈Parts № 45〉 3 – 7 Compressio

(2) Disconnect the fuel hoses from the fuel pipes. ※ It is possible that these hoses may be pressurized. When removing, cover hose with a towe

15 3 – 9 Engine Control Module Installation (ECM) Place the ECM back to its original position and connect the harness to the ECM. 3 – 10

GReddy Turbo Kit 02-05 VW GOLF GTI Ⅳ TD04-19T 8.5cm2 1

02-05 VW GOLF GTI Ⅳ TD04-19T 8.5cm2 Installation Manual Please read the entire manual before installing this kit. Application: Make

11. Oil Pressure Banjo Fitting Small (Male&Female) 1 12. “ Big (Female) 1 13. Plug Bolt M14mm

Parts List 1 2 3 4 5 6 7 8 9 10 11 12 １3 14 15 16-18 19 20-21 22 23-24 4

25 26-27 28 29-36 37 38 39 40 41 42 43 44 45 46 47-53 54 5

２．Remove Stock Parts Please refer to the manufacture repair manual for removing stock components. ２－１ Disconnect the batter (-) terminal. ２－２

２－16 Remove the turbo oil supply pipe Assy. After removing, reinstall the oil supply pipe bracket bolts to their original positions. ２－17 R

3 - 3 Turbo Installation (1) Place the included O ring where the suction tube connects to the turbo inlet and use provided bolt to in